批发彩钢岩棉夹芯板 复合夹心彩钢板岩棉夹芯板 屋面保温板     100米

    彩钢岩棉夹心屋面板，有效宽度为960mm，保温层厚度50mm，75mm，100mm，瓦峰高度40mm；彩钢夹芯板的构成如下：上板采用1200mm宽的红色，蓝色，白色，灰色等彩钢板，下板用1000mm宽的白色0.2mm-0.6mm厚的彩涂卷，中间复合岩棉容重80kg/m3，上下两层钢板通过双组份胶黏剂与岩棉粘合在一起，纵向两侧封闭镀锌钢带，钢带与上下钢板紧密咬口在一起，大大增强了整体板材的强度，提升板材的整体美观度；夹芯板有母口和子口，安装时子口插入母口，用钻尾钉在两口搭接处穿透固定在屋面檩条上，与每个檩条的搭接处必须固定一个钻尾钉，待整张板材固定完毕后扣上扣槽，在扣槽靠近板材的边缘处用钻尾钉与板材固定一下，防止大风时吹落扣槽。

    铺完夹心板然后安装附件，顺序如下檐口扣件——封堵——侧封——脊瓦下挡水件——脊瓦——附件接缝处打耐候结构密封胶。

     The color steel rock cotton sandwich roof board is white, the effective width is 960mm, the insulation layer thickness is 100mm, the height of the tile peak is 40mm, and the overall thickness of the plate is 140mm. The composition of the color steel sandwich panel is as follows: the upper board is painted with red 0.4mm thickness of 1200mm width, The bottom plate was painted with 1000mm wide white 0.2mm thick color, and the middle composite rock wool 100mm thick bulk density was 50 kg / m3 white. The upper and lower layers of steel plate bonded together with rock wool through two components of adhesive, and the longitudinal sides of the galvanized steel strip were sealed, and the steel belt and the upper and lower steel plates were closely nibbled together. The strength of the whole plate is greatly enhanced, and the overall aesthetic degree of the plate is raised. The sandwich board has a master and a sub-mouth, which are inserted into the master port during installation, and are fixed on the roof purlin by 5.5*135mm drill tail nailing at the two lap joints. The overlap with each purlin must be fixed with a drill tail nail, after the whole plate is fixed, the buckle groove should be buckled, and at the edge of the plate, the pin should be fixed with the plate to prevent the wind from blowing off the buckling groove. Finish the sandwich plate and install the attachment in the following order: cornice fastener-sealing-side seal-water retaining piece-ridge tile-attachment joint with weathering structure sealant.